The advance copy of my new book arrived today, and I’ve shared some previews here
Tag: textile design
Colour-changing yarn spun from a distaff
I’ve had a number of different colour hand dyed carded batts sitting waiting for me to find inspiration. They are all from fleece I have scored and carder myself, so are a mix of Shetland, Suffolk and Texel, with maybe a little Alpaca blended into some of them. Some are in 200g amounts, some less. I’d got a bit stuck about how to use them until I saw a useful tip by Anna from my spinning group that she has put on YouTube.
Before you start, select a group of colours that work together. After a designing session during which I wrapped different colours together, I chose five: orange, pale green, mid blue, pale blue and lilac.
Anna used a combination of hand dyed and commercial roving, but the principle is the same with your own carded batts.
1. First of all split the roving/batt into the required lengths, (I just used the whole length of the batt of my drum carder).
2. Then split each length lengthwise into 4, (or more, depending on the thickness of the roving/batt).
3. Next, lay out the colours lengthwise, next to each other in the order you want to spin them into yarn. Test this beforehand to see how they mix throughout one repeat of a yarn, and if this works for your chosen outcome, such as knitting.
4. Repeat the colour sequence three more times so you have a table full of ‘stripes’ of fibre. If you have more than four lengths let colour, carry on until all are used up.
5. Now this is the clever part. I have hand spun colour changing yarns before and got the sequence wrong because I put it all away in a box between spinning sessions. To keep the sequence do the following.
6. Take a metre + long length off ribbon and tie a pencil or empty pen across one end. This is your fibre-stopper. Tie a hand-sized loop on the other end. This is your distaff.
7. Starting at one end of the ‘stripes’, wind each length off fibre into a loose roll and slip the looped end of the ribbon through the centre hole. Carry on doing this, working methodically through the fibre lengths, keeping the colour order as mapped out in your ‘stripes’.
8. You will end up with a ‘necklace’ of colour ordered fibre rolls on the ribbon. Tie the ends together to stop the fibre sliding off.
Now to can put them in a box and they won’t get muddled. To start spinning, simply lift the necklace out, untie the ends, and slip the loop over your hand. It acts as a distaff and will hold your fibre nicely as you spin each colour.
What a great tip!
I plied the colour changing yarn with a single spun made from navy blue Corriedale. This made a lovely marl yarn that to me resembles stained glass windows. I can’t wait to see what it looks like knitted.
Here is the link to Anna’s video
Today I finally completed a top-down jumper I started last December! I bought the main 100% wool yarn in Hereford, and the stripes are worked in two odd balls, one Noro and the other Icelandic. I’m looking forward to hearing it next winter.
Talk in March 2020
I will be talking to Long Buckby Machine Group next March about my career in knitted textile and knitwear design, and the inspiration behind ‘Translating Between Hand and Machine Knitting’.
I’m looking forward to meeting members of this well-established machine knitting group.
Kaffe Fassett ephemera
I found this when clearing out my studio. Was this really in 1988? How time flies…
Satisfaction is a bobbin of plied yarn
I love the final plying process when spinning yarn. This is Texel and Clun Forest wool fibre, processed from raw fleece. One single of each as an experiment.
I find it very difficult to get a smooth yarn from my own prepared raw fleece. It’s pretty easy from commercially prepared tops, but getting all those little nepps and second cuts out is pretty impossible for me.
I’ll wash this and see how it comes out.
Whilst on the same website I found a video on eco dyeing. I’ve seen some before but in this film Mo Jackson explains it really well.
eco dyeing on Woodland TV.
I’m now itching to have a go on a plain silk scarf I dyed with avocado stones.
Food colour dyeing
Today I wanted to dye some of my hand spun wool yarn a bright green. No natural dye I have would do this, and I didn’t have any green acid dye, (or any acid dyes at all), so I decided to use food colouring. I already knew that food colouring works as a fibre dye but did not realise that it was an acid dye, (thank you Google) so works best on wool, silk and other protein fibres that will dye with an acid dye. Acid dyes are not acid, but they require an acid such as vinegar or citric acid to attach themselves to the fibre.
Initially I’d intended to use liquid food dyes but discovered I have either thrown them out or someone had used them up, so had to resort to the paste colours I used to use for sugar flower modelling. These seemed to work fine and are quite intense, if a little harder to dissolve, (I had to squash some lumps against the side of the jug). I may use them again as they are just sitting in the cupboard at the moment.
So to prepare the yarn I soaked it in a mixture of one part vinegar to two parts water for about 30 minutes. This did two jobs at once, soaked the fibres to remove trapped air and added acidity. I could have added vinegar to the dyebath instead.
Meanwhile I put some water to heat on the stove and mixed the bright leafy green I wanted from my stash of food colouring dyes.
I mixed the food colouring paste with hot water in a small jug, and added a teaspoon of salt, (this helps to level the colour and increase its take-up), stirring them well until the liquid was clear, then added this to the pan of water that was warming on the stove.
When the dyebath was ready I removed the hank of wool from the vinegar and water soak, gently squeezing it to remove excess liquid, and immersed it in the dye. The temptation to stir the yarn into the dye bath is always with us, so I gently prodded it below the surface and walked away and left it. It took about 20 minutes of gentle simmering, turning the yarn very gently once, to achieve the colour I wanted.
Because I liked the colour so much I decided to dip a second hank quickly into the dyebath so I got very pale green and then, having rinse it to check the colour, I trailed half the hank into the dyebath again and let it stay in there until it became darker. This gave me a dip dyed, ombre yarn in tones of the same green.
Post-dyeing rinses brought the brightness down a little on both hanks, but overall I was pleased at how little colour came out. I rinsed quite hot; wool can take high heat and won’t felt, as long as you don’t agitate it or put it straight into cold water. The important thing is to have the rinsing water at a similar temperature to the dye bath. Wear gloves to protect your hands during these hot rinses. To save energy you can slowly decrease the temperatures through the rinses. Never let the tap run onto the wool or it is likely to felt.
Because it was a lovely day today I hung the hanks out in the garden to dry, but you can spin dry them as long as you put them inside a mesh laundry bag or a calico bag.
Both yarns were handspun with a bouclé effect. The dip dyed one took the colour less well partly because it was from a different fleece, and partly because it should really have had an additional scour before going into the vinegar soak.
Brighton Textile Art Group meeting 11th May
Well I did it, I made it along to the meeting today and joined the group. Thank you to all the kind members who made me feel so welcomed. There was a natural dyeing workshop today, but of course I had not booked in advance. However, I had taken along my Spurtzleur with some fibre being spun into singles as work in progress, and had some other singles I had spun earlier in my bag. So I finished off the singles on my Spurtzleur and plied this using my hands in an Andean ply. Then I did the same with the singles in my bag (they were from different fleece). This meant I had two little hanks to dye in the onion skin and the daffodil dye baths.
Click on the photo to visit the brighton Textile Art Group website and see what other events and workshops are in the future.
There is a little more detail of the day on my Natural Dyeing page.
About Translating between Hand and MachineKnitting…
‘Hi, I’m Barbara from Italy and want to thank you for writing “Translating between hand and machine knitting”. It’s just great, I can now understand the differences between silver reed and brother. I have one of both but got frustrated trying to use the silver reed, so just stopped working with both… now I have the chance‘
Thank you Barbara, its great to hear your feedback.